Contemporary Screwless Socket & Switch Sale Contemporary Screwless Socket & Switch Sale
Screwless Socket & Switch Sale
Save 25% On All Contemporary Screwless Sockets & Switches »

How To Install A Double Pole Switch

For 20, 32, 40, 45 & 50 Amp Double Pole Switches

Connect the cables as shown in the diagram.

Double Pole Switch Wiring Diagram

Wiring diagram for a double pole switch
For clearer image, click on the image

Alternative Style Double Pole Switch Wiring Diagram

Wiring diagram for a double pole switch
For clearer image, click on the image

Important

If in any doubt on how to proceed, consult a qualified electrician.

All work carried out should comply with all applicable Wiring Regulations.

Read the instructions carefully before commencing installation. Incorrect installation will invalidate your guarantee.

Metal plate sockets and switches must be correctly earthed.


Make sure that the load cable is connected to the appliance to be switched and that this switch is earthed.

Do not connect this switch directly to a ring circuit.


Please Note

  • Always ensure that the mains supply has been suitably isolated before commencing installation.
  • Remove the existing socket or switch from the wall (if replacing).
  • Remove any plaster debris and dust from the inside of the wall box.
  • Always use the correct type of cable that is rated appropriately.
  • The terminal layout may vary from one socket or switch to another, therefore carefully check the location of the terminal connections before wiring.
  • For sockets and switches supplied with a clear plastic gasket, position it between the wall and the accessory. This gasket must therefore be placed over the wires before they are connected to the accessory.
  • Connect the new socket or switch as shown in the appropriate wiring diagram in these fitting instructions taking care that only the copper conductor(s) enter the terminals. It is absolutely vital that the terminal screws do not clamp on the insulation of the cables. When using multicoloured (stranded) cables make sure that after the terminals have been tightened, no stray strands are left outside the terminals. If necessary, trim and strip the cable to suit.
  • Important: Metal decorative sockets and switches must be correctly earthed. This is achieved by connecting the fixed earth wire to the earth terminal on the socket or switch and then connecting a short length of wire from this terminal to the earth terminal in the wall box. Use appropriate green/yellow sleeving if required.



Find Double Pole Switches To Match My Room

Choose from over 100 modern and traditional socket and switch styles, with the full range of light switches, plug sockets, dimmers, USB sockets, phone, satellite & tv sockets, fused spurs and more. Just start by choosing your finish to see the styles availables.

© 2024 Sockets And Switches
Sockets & Switches, Unit A5, Quarry Park, Old Milverton Lane, Leamington Spa, Warwickshire, CV32 6RW  |  [email protected]